This acrylic-based, industrial-strength product dispenses resin and hardener automatically into equal parts with one push. Hold surfaces together with clamp, tape or weights. Allow 5-10 minutes for set time. 4000 psi strength bonds numerous plastics and works well for repairing plastic toys, fixtures made of plastic, metal, concrete and many other materials. Cures to an opaque light yellow color.
(Note: not recommended for polyethylene or polypropylene bonding).
1.Surfaces should be clean and dry, free from oil and grease.
2.Roughen surfaces with emery cloth or sandpaper & wipe clean with solvent for best results.
3.Dispense from syringe and mix thoroughly, approximately 1 minute.
4.Apply to both surfaces and mate parts together.
5.Remove excess glue immediately with denatured alcohol.
6.Sets in 5-10 minutes at room temperature (77Ā°F or 25Ā°C) with full cure in 24 hours.
Initial color: Light yellow to amber
Final color: Light yellow
Positioning Time: 3 ā 5 minutes
Set Time: 5-10 minutes @ 65-80Ā°F
Handling Time: 2 hours
Full Strength: 24 hours
Maximum Gap: .25″
Shear Strength, Steel: 4000 psi (20%); Aluminum: 3500 psi (20%)
Operating Temperature Range: -40Ā°F to 250Ā°F (-40Ā°C to 121Ā°C)
